Engineering

1. To perform a facing cut using a tool with a nose radius of 1/32, what will the programmed X-axis end point at the center of the part be?

2. Explain the difference between rigid tapping and tapping using a floating tap holder.

3. How must the feed rate for tapping using a floating holder be programmed differently than that for rigid tapping?

4. Describe what happens to a concave radius (fillet) when cut without using TNRC. A sketch may be used to help.

5. Describe what happens to an outside chamfer when cut without using TNRC. A sketch may be used to help.

Solution:

Looking for help with your homework?
Grab a 30% Discount and Get your paper done!

30% OFF
Turnitin Report
Formatting
Title Page
Citation
Place an Order

Grab A 14% Discount on This Paper
Pages (550 words)
Approximate price: -
AllEscortAllEscort